[Free] 2018(May) EnsurePass Braindumps Cisco 300-080 Dumps with VCE and PDF 101-110

Ensurepass.com : Ensure you pass the IT Exams
2018 May Cisco Official New Released 300-080
100% Free Download! 100% Pass Guaranteed!

Troubleshooting Cisco IP Telephony amp; Video v1.0

Question No: 101

Which statement indicates something that can cause an inbound PSTN call to an H.323 gateway that is configured in Cisco Unified Communications Manager to fail to ring an IP phone?

  1. The gateway is not registered in Cisco Unified Communications Manager.

  2. The gateway IP address that is configured in Cisco Unified Communications Manager does not match the IP address that is configured at the gateway in the h323-gateway voip bind srcaddr command.

  3. The Cisco Unified Communications Manager does not have a matching route pattern to match the called number.

  4. The gateway is missing the command allow-connections h323 to h323 under the voice service voip configuration.

Answer: B

Question No: 102

Which four performance counters are available when monitoring a Cisco MTP device using the Cisco Unified Communications Manager RTMT? (Choose four.)

  1. Resource Total

  2. Resource Available

  3. Out of Resources

  4. Resource Idle

  5. Resource Active

  6. MTP Streams Active

  7. MTP Connection Lost

  8. MTP Instances Active

Answer: A,B,C,E

Question No: 103

Phone A is able to dial the directory number of Phone B and complete a call. However, when Phone B dials the directory number of Phone A, Phone B receives a fast-busy tone. What is causing this issue?

  1. Phone A and Phone B are in different partitions.

  2. Phone B does not have Phone A in its partition.

  3. Phone B is not in the CSS of Phone A.

  4. Phone B does not have the CSS of Phone A in its partition.

  5. Phone B is not registered.

  6. Phone B has the incorrect CSS to dial Phone A.

Answer: F

Question No: 104

You must integrate a third-party H.323 system with your existing Cisco Unified Communications Manager cluster. When you create an H.323 trunk from the cluster, calls from the cluster to the third-party H.323 system are failing. The vendor of the third-party

H.323 device has confirmed that the H.323 call setup time must be reduced. Which two approaches reduce the call setup time from Cisco Unified Communications Manager to the third-party H.323 device? (Choose two.)

  1. Implement a software MTP.

  2. Implement a hardware MTP.

  3. Implement transcoding with the router DSP resources.

  4. Implement transcoding with the Cisco Unified Communications Manager resources.

Answer: A,B

Question No: 105

When a user attempts to log out from Cisco Extension Mobility service by pressing the services button and selecting the Cisco Extension Mobility service, the user is not able to log out. What is causing this issue?

  1. The Cisco Extension Mobility service has not been configured on the phone.

  2. The user device profile is not subscribed to the Cisco Extension Mobility service.

  3. The CTI service is not running.

  4. The logout URL that is defined for the Cisco Extension Mobility service is incorrect or does not exist under the IP Phone Services configuration.

Answer: B

Question No: 106

URI dialing is enabled between two clusters with the default options. The engineer that set up the URI dialing verified that all was working properly. However, a user from one of the clusters cannot dial using URI to a user in the same cluster. What do you do to resolve this issue?

  1. Verify the password that is used by the authentication under Intercluster Lookup Service configuration.

  2. Find out if the URI address of the called user has a capital letter in the URI string.

  3. Verify that Intercluster Lookup Service is set up correctly.

  4. Verify USN Data Synchronization Status.

Answer: B

Question No: 107

When identifying Cisco TelePresence Endpoint traffic characteristics, which three statements are true? (Choose three.)

  1. Latency, jitter, and loss are measured in a round-trip fashion.

  2. Latency, jitter, and loss are measured unidirectionally.

  3. Latency and loss are measured at a packet level, based on RTP header sequence numbers and time stamps.

  4. Latency and jitter are measured at a packet level, based on RTP header sequence

    numbers and time stamps.

  5. Jitter is measured at a video frame level, by measuring the arrival time of the video frame versus the expected arrival time.

  6. Jitter is measured at a packet level, by measuring the arrival time of the packet versus the expected arrival time.

Answer: B,C,E

Question No: 108

Which CLI command monitors ILS replication progress?

  1. utils ils findxnode

  2. utils ils show peer info

  3. utils ils showpeerinfo

  4. utils ils lookup

Answer: C

Question No: 109

When parsing trace output after the call routing decision and path selection have been made, which two records can be found in the CCM|RouteList? (Choose two.)

  1. PretransfromDigitString

  2. CallingPartyNumber

  3. PretransformCallingPartyNumber

  4. RouteListName

  5. findLocalDevice

  6. RouteListCdrc :

Answer: D,F

Question No: 110

When a user tries to initiate an Ad Hoc conference call from an IP phone, this message appears: No Conference Bridge Available. Which two actions resolve this issue? (Choose two.)

  1. Make sure that the Join softkey is assigned to the phone.

  2. Make sure that a Conference Bridge resource is registered to Cisco Unified Communications Manager.

  3. Reset the phone, to re-register resources.

  4. Make sure that a Conference Bridge Resource is assigned to the MRGL on the phone that initiates the conference call.

Answer: B,D

100% Ensurepass Free Download!
Download Free Demo:300-080 Demo PDF
100% Ensurepass Free Guaranteed!
300-080 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

Your email address will not be published. Required fields are marked *